Samsung Usb Driver For Mac
The BIXOLON SRP-270 receipt printer is an ideal printer for point of sale and hospitality applications. The modular userfriendly design, graphics capability, and 4.6 lines per second print speed offer reliable high performance in a compact, lightweight design. SRP-275APG is a Receipt Printer by Bixolon in the SRP-275 product line. Bixolon SAMSUNG, 3' Dot Matrix Impact Printer, Parallel Interface, with Tear Bar, Color: Dark Gray.
The SRP-275 remote printer is not a commonly used printer of POSNation. However, it may be used as an Epson emulation printer in many cases. Below are some outlined steps to configure this printer at the Windows level. Once this is complete, you may reference Epson setup documents for specific applications to perform Point of Sale specific setup.
Hardware Identification:
- Printer has the designation SRP-275
- Comes with printer ribbon, starter paper roll, and power cables.
Windows Configuration:
I. Download Network Config Utilitiy and user manual from: http://www.bixolon.com/_eng/download_center/downloadsub.asp?uid=443&p_uid=26 (www.bixolon.com > Interface Cards > Ethernet > Downloads > Configuration Tool V5.00)
II. Download Windows Driver from: http://www.bixolon.com/_eng/download_center/downloadsub.asp (download the “Windows Driver V.3.2.EA, or the latest available).
III. Physical Connectivity:
A. Connect printers to LAN and power.
IV. Assign Static IP addresses to each SRP-275 printer:
A. Install Configuration Tool
B. Click Search to locate printers on network: They will be listed under Board List
C. Pick a Board (MAC Address) to show it’s current IP settings
D. Key in desired IP settings (do not change port or Inactivity)
E. Click Setting to save changes to the printer
Samsung Bixolon Srp-275 Apg Driver For Mac
V. Installing Windows Print Driver:
A. Run the Windows Driver Installer
B. Select a COM or Parallel Port during the installation process
C. Once the printer instance shows up in printers and faxes, change the name to something meaningful, such as the printer location or job role.
D. Create a generic TCP/IP port assignment with default settings for the printer’s static IP address
E. Perform test print to verify functionality
VI. Follow steps above to assign a static IP and install the windows driver for each SRP-275 ethernet printer on the network.
VII. If other computers will also connect to the printers, Windows Driver Installation steps must be completed on other computers.
VIII. Reference Epson U220 articles for Aldelo or CRE to complete Point of Sale configuration of the printers.
Common Problems:
I. Printer prints question marks during test print.
Older NIC card versions have a designation on the card face”IFC-E”. When running the Network Configuration Utility, you must be sure to match the baud rate setting on the tool with that of the printer. 19200 bps is the default. A self test may reveal the current settings on the printer. If not, you may change the baud setting in the Config Utility, Click the Setting button to save, and test print again. Try all baud rates unit one of them prints a legible windows test page.
New cards with the designation “IFC-EP” are not dependent on the baud rate setting, as they are new technology.
Canon Printer Driver For Mac
II. Printers do not show up on the Configuration Utility:
If they don’t show up, move printers directly next to the router or switch and connect directly to confirm that network cabling is connected properly for initial setup. Then move printers to remote location. If they don’t work after moving, something is wrong with the network wiring.